The IP address is the internal IP address of your appliance. Configure the IP Address and Shared Secret for the Client so that they correspond to the configuration of your VPN appliance.Give the RADIUS client a memorable name for easy reference.Click the hostname, then click Create New Radius Client.Navigate to Components > RADIUS and locate the hostname of the server running the ESA RADIUS service.To allow the Fortinet FortiGate® SSL VPN device to communicate with your ESA Server, you must configure the Fortinet FortiGate® SSL VPN device as a RADIUS client on your ESA Server: If you wish to utilize other Client type, refer to generic description of Client types and verify with the vendor if the VPN appliance supports it. With the above config, the same subnet can be learned and installed in FIB by IKE through different phase1s.This integration guide utilizes Client does not validate user name and password Client type for this particular VPN appliance.
Set route-overlap allow <- The default is "use-new" If not, only one of these two links (phase1s) will be installed at a time. If there is a network setup or design where the same subnet can be reached through two different phase1s, like the dual link or ECMP to the same network, this can be an issue in a dial-up VPN environment unless there is the right setting under VPN. This article explains how FortiOS manages route overlap (when two or more dialup clients advertised the same protected network/subnet to the HUB).įortiOS uses an add-route to announce the network has been encrypted by a spoke or dialup client to the HUB and eventually adds this route to the FortiGate FIB, this takes place during the dynamic tunnel negotiation.
0 kommentar(er)
